Push
Push
( fig.2)
Insert the exposed ends of the joint connectors
into the short (vertical) frame and align the four
corners so that they meet at perfect right angles
4. Join all four frame parts together following the steps showed below. (fig.2)
5.
After making sure that all four corners join at right angles to form a perfect rectangle, fasten the four
angles together by using the (x8) joint screws included. (see fig.3)
6.
Lay out the screen and tension rods on a clean and dry surface. Pass the screen
tension rods through the sleeves according to their corresponding lengths on each
edge of the screen as seen below. (see fig.4)
(3)
Screw
( fig.3)
To Next Page
Loading...
