3. Slide the top end of the bar into the top center point location to complete center support bar
installation. This will provide added stability to your frame and added tension to the material.
Installation
1. Locate your desired installation location with a stud finder (recommended) and mark the drill-hole
area of where the screen is to be installed.
2. Drill a hole with the proper bit size according to the wood screws included.
3. Line up the small wall brackets with the drilled holes on the installation location and screw them in
using a Philips screwdriver.
4. Position the fixed frame screen onto the top wall brackets as shown in (fig. 9) and push down at
the center of the bottom frame rail to hook into the lower wall bracket.
(7)
small wall bracket
4pcs
( fig.7)
Method 1 (smaller than 135" diagonals)
Center Support Bar
(Fig. 8)
To Next Page
Loading...
