Elite Screens Elite Ez-Frame Series - Black backing for AcousticPro1080 models

Black backing for AcousticPro1080 models
This procedure only applies to AcousticPro1080 models, disregard if your ezFrame is not an
AcousticPro1080 variant. The black backing counters the effects of light penetration that
would otherwise light up all items behind the screen and spoil the picture.

（ fig.6 ）
(5)
Fix plate secures AcousticPro1080 material and
the black
backing
behind it.
AcousticP
r
o1080 Sc
r
een
Material Cover by Black backing
Fix Plate
Tension Rod (stretches the
AcousticPro1080 material)
Black backing for
AcoousticPro1080
*An alternate way to attach the black backing is to utilize the Velcro tabs attached to the tops of the fix plate’s tail
(Fig. 4). The material will grab and hold tight to the Velcro as it lays over the tails of the fix plates themselves and
stretched from tab to tab around all four sides.
After the material has been installed, the backing will lay over the back of the white (AcousticPro1080) material and
then be held into place by the fix plates as they are added (Fig.1-3). Interval markings reveal the best likely points of
attachment (Fig. 1). The prongs on the fix plates (Fig. 2) straddle a lip on the back of the frame creating a friction
hold that will firml
y
kee
p
the material and backin
g
in
p
lace
(
Fi
g
. 3-4
)
.
The black backing goes behind the projection surface and are held into position by Velcro-faced fix plates.
Fig. 1
Fig. 3
Fig. 2
Fig. 4
Black backin
g