Elite Screens Elite ezFrame Series - Attaching the Screen Material; Installing Tension Rods; Securing Material with Fix Plates

Tension Rod (Horizontal) x 4
Tension Rod (Vertical) x 2
Tension Rod (horizontal)
Push
Tension Rod (Vertical)
Attaching the screen material to the frame
1. Lay out the screen and tension rods on a clean and dry surface. Insert the screen tension rods
through the sleeves according to their corresponding lengths on each edge of the screen as seen below.
(see fig.4)
2. Place the screen material on the back of the built frame and slip the tension rods into the grooves
running along each side on the back of the frame on all four corner and clip on the fix plates to the back of
the frame to secure the rods into place creating tension for a tight and flat surface
(see fig. 5 & fig. 6)
(4)
Steel rod
Push
( fig.4)
Steel rod
Screen
Push
Rod
Rod
Push
( fig.5)
Viewing surface
(Front of screen)
Steel rod
fix plate
Tension Rod
(fig. 5)
(fig. 6)