Rev.102212-JA 7 www.elitescreens.com
B. Below ceiling installation instructions
Please make sure all parts listed below are included before proceeding with the installation.
Hardware Parts List for below ceiling installation
E. M8x16mmx1.5mm
washer x 28
G. M8 Top expanding bolt x 4
1. Measure and cut the ceiling installation slot:
The width should not exceed 100mm and not less than the width of the screen’s housing. Measure the
length of your screen to determine the length.
Note: The length of the installation space is not greater than the screen size table (C3), and the width is
not less than the screen size table (A5). Consult the dimensions table on page 9 (C1) in regards to
accommodating the screen casing.
2. Drill 4 holes in the ceiling that correspond with the attachments on the various casing sizes. The
width should be 120mm. The length of (A5) in the diagram below depicts the distance between
the holes located on each ear end of the screen’s case.
To Next Page
Loading...
