Joan Oró, 27 Pol. Ind. Sesrovires- St. Esteve Sesrovires, BCN, España– +34 932 935 178 – ! info@elite.es
The electrical connection of the machine must be carried out by qualified technical personnel
only at the voltage indicated in the machine order / machine identification plate.
For any doubt about the voltage, consult the manufacturer before the connection.
Any claim for an incorrect connection will be out of warranty.
The machine is delivered without a plug and must be connected to a three-phase mains (480 /
400V or 220V + N + Pe), as described on the plate located on the rear side of the machine.
Connect only the ground wire with the yellow-green (grounding) intermediate wire.
The direction of rotation of the motors must be checked by turning the pump motor on and
check that it turns in the correct direction.
ELITE does not assume any responsibility in the event of an incorrect electrical installation
that may cause a malfunction of the machine and even personal or material damage.
To Next Page
Loading...