Joan Oró, 27 Pol. Ind. Sesrovires- St. Esteve Sesrovires, BCN, España– +34 932 935 178 – ! info@elite.es
7.MAINTENANCE
Our machines require very little maintenance. In any case, it is recommended to carry out the following
operations periodically (ATTENTION: before pressing the emergency button or disconnecting the
machine):
• Daily: General cleaning of the machine.
• Weekly: Lubrication of the X-axis guide.
• Periodically: Replacing the drill (if applicable)
To replace the grinding wheel, proceed as follows:
Switch off the machine using the general switch.
Remove the two M5 or M6 allen screws located on the front of the
grinding wheel.
Remove the grinding wheel and proceed with its replacement.
8.PROBLEMS AND SOLUTIONS
In case of malfunction please refer to the following instructions, taking into account that it is usually neces-
sary to act on different parameters to solve a problem:
Some tips and solutions for potential problems:
• The machine does not start.
Solution - Check that the connection of the machine to the three-phase grid is correct and that the
supply voltage corresponds to that indicated on the nameplate located on the machine. Check that the
motors rotate in the direction indicated by the arrows, otherwise reverse the position of two of the wires
in the socket.
To Next Page
Loading...