Keep Working
KEEP WORKiNG
03
MC5
Fig 1
4. Installation
sliding gate opener is applicable to gate weight less than 300kg, and length of the sliding gate less than 8m. The drive mode
adopts the rack and gear transmission. This gate opener must be installed inside the enclosure or yard for protection.(Fig1).
Preparation work before installation
Please make sure that the sliding gate is correctly installed, the gate rail is horizontal, and the gate can be manually moved
smoothly before installing the gate opener.
Cable installation
In order to guarantee the normal operation of the gate opener and protect the cables from damages, please bury the motor
& power cable and controlling cable separately with two PVC tubes.
Concrete pedestal
Please precast a concrete pedestal with the size can be 400mm x 250mm, depth be 200mm in advance, so as to firmly
install gate opener. Please make sure the distance between the gate and gate opener is appropriate before casting the
pedestal.
Anchors (Ver Fig. 2)
You can use anchor bolts, anchors, washers, and nuts. These anchors must be set in the concrete when it is poured or you
can use wedge anchors to support the motor.
Sliding door
Rack
Switch
Wall
Input power
Gate opener
To Next Page
Loading...