24
ENGLISH
GB
• If the lever (F) starts pressing the quick release
in the advanced work position (fig.16), screw the
left bushing pin (C) (fig.17) so that the lever starts
working inside the predefined work area (between
30° and 45°).
• If the lever (F) starts pressing the quick release
in the delayed work position (fig.18), unscrew the
left bushing pin (C) (fig.19) so that the lever starts
working inside the predefined work area (between
30° and 45°).
• After establishing the correct position of the left
bushing pin (C), hold the left bushing pin with one
hand (C) and with the other, tighten the ring (D)
(fig.20) thus clamping everything.
• Close the lever (F) in the “close” position,
pushing it only with the palm of the hand (fig.21
and 22) and taking care not to put fingers between
the lever and frame (fig.23).
16
17
18
19
20
21
To Next Page
Loading...
