Elived EV014 - Page 7

2B-4
01
A
B
01
Install wall plate using lag bolts
and washers . Tighten the lag bolts
until until they are pulled firmly against
the wall plate .
A
01
A
B
UP
3-1
Fasten the all 8 screws.
2. Remove the
pre-assembled screws x4
3. Insert the arm extension
Install the extensions to Front support with the pre-assembled screws.
1. Loosen a little
02
02
03
03
STEP 3 Install Front Support and Extensions
7/32 in.
Ø5.5 mm
in. (70 mm)
Drill pilot holes using a 7/32 in. (5.5 mm)
diameter drill bit.
IMPORTANT:
Pilot holes must be
in. (70 mm).
Be sure to drill into the center of the stud.
drilled to a depth of
- 7 -
2
Use the wrench if you don't have
socket wrench in hand.
05
05
2B-3