EZ8WSLSMC_1G EZ8WSSSMC_1G LZ8WSLSMC_1G LZ8WSSSMC_1G
(630) 574-8484 Elkay Manufacturing Company
1000006140 (Rev. A - 03/21)
Page 5
Shock and Electrocution Hazards
Failure to follow these instructions could result
in severe burns, signicant injuries, and even
death.
Water will conduct electric current to
create a short circuit, resulting in
injury or death.
• Never use electric power tools around water or
wet oors/surfaces.
• Keep all liquids away from electrical cords and
power tools.
• If an extension cord is required, always use an
OSHA approved cord.
• DO NOT create a short circuit between a source
of electricity and a liquid by being in contact with
both simultaneously.
Contacting live electrical wiring with
power tools or hand tools can cause
serious injury or death.
• Make sure all related circuit breakers are turned
OFF.
• Test for live circuits or wiring inside any wall
where installation of the product requires cutting
into a wall.
Prior to any maintenance, make sure the
unit is unplugged and circuit breakers are
turned OFF.
Prior to installation, test for live circuits or
wiring inside the wall before cutting or
drilling into the wall.
These cautions indicates a potentially hazardous
situation which, if not avoided, may result in minor
or moderate injury. Follow all instructions related to
installation and/or maintenance of this product.
Tripping Hazard
Personal injury can result from tripping over
power cords, tools, or other installation items.
DO NOT leave items laying around the work area.
Cutting Hazard
The installation of this product may require
using power tools.
Keep hands away from the cutting edge of any
tool used in the installation of our product.
Placing ngers in or around the cutting blades
could result in serious personal injury.
3. Tools and Supplies
3.1 Tools Required
Tool Used For
Tape Measure Locating mounting brackets
Level Mounting bracket installation
Power Drill Installation of wall anchors or lag screws for
mounting plate
Adjustable Pliers Installation of P-trap
Adjustable Wrench Installation of water inlet valve
Hacksaw Trimming waste outlet pipe
Flat Blade
Screwdriver
Adjustment of pressure regulator and
coldness control valve
5/16” Nut Driver Removal of mounting bracket and front
panel
5/32 Allen Wrench Removal of bottle filler front and top covers
Tubing Cutters To trim excess poly tube
Bucket For draining old filter for filter cartridge
replacement
Towel For replacing the filter
To Next Page
Loading...
Need help?
General
