Elkay LZ Series - User Manual

To reset the lter count on original EZH2O bottle lling stations like the one above,
you will rst need to access the control board toggle switch.
To do this, you will need to rst open the top of the bottle ller by removing the
two screws on the top. They are hex type (non-security), so you will need
a 5/32 Allen wrench.
UH-OH...
You’ve changed the lter,
but the light is still red!
COMMERCIAL RESTROOM ACCESSORIES
Distributed By
WWW.RESTROOMDIRECT.COM
704•937•2673
129 Oak Park Dr., Unit A,
Mooresville, NC 28115

Summary

Resetting the EZH2 O Filter Indicator

Identifying the Red Light Issue

Describes the condition where the filter light remains red after replacement.

Accessing the Control Board

Instructions on opening the bottle filler to access the control board.

Required Tool for Access

Specifies the 5/32 Allen wrench needed to remove top screws.

Toggle Switch Interaction

Details pressing and holding the toggle switch to initiate the reset sequence.

Navigating LCD Display Options

Explains how to cycle through display options like 'SETTINGS' and 'RST FLTR'.

Confirming Filter Reset

Describes the final display 'FLTR =0' and the illuminated green LED.

Elkay LZ Series Specifications

General

Product Type	Water Dispenser
Mounting Location	Wall-mounted
Power	Electric
Finish	Stainless steel
Temperature Options	Chilled
Dimensions	Varies by model
Weight	Varies by model
Power Requirements	115V, 60Hz