Elkay LZSTL8WSLK - User Manual

To reset the lter count on original EZH2O bottle lling stations like the one above,
you will rst need to access the control board toggle switch.
To do this, you will need to rst open the top of the bottle ller by removing the
two screws on the top. They are hex type (non-security), so you will need
a 5/32 Allen wrench.
UH-OH...
You’ve changed the lter,
but the light is still red!
COMMERCIAL RESTROOM ACCESSORIES
Distributed By
WWW.RESTROOMDIRECT.COM
704•937•2673
129 Oak Park Dr., Unit A,
Mooresville, NC 28115

Summary

EZh2 O Filter Reset Procedure

Preparation: Accessing Internal Components

Open the bottle filler top by removing two hex screws with a 5/32 Allen wrench to access the control board.

Performing the Reset Sequence

Press and hold the toggle switch, then click it when 'RST FLTR' appears on the LCD to reset the filter counter.

Verification of Reset

Confirm the filter reset by checking the green LED and the 'FLTR =0' display on the LCD screen.

Elkay LZSTL8WSLK Specifications

General

Brand	Elkay
Model	LZSTL8WSLK
Category	Water Dispenser
Filtered	Yes
Bottle Filling Station	Yes
ADA Compliant	Yes
Material	Stainless Steel
Cooling Capacity	8.0 GPH
Installation Type	Wall Mount