Elkay LZSTLDWS 1G Series User Manual

Page 1 1000002243 (Rev. J - 08/21)
EZSTLDWS*1G EZSTL8WS*1G, 2G, 3G LZSTLDWS*1G LZSTL8WS*1G, 2G, 3G
EZ™ & LZ™ Stations versatile de Remplissage de Bouteille Série et Refroidisseurs
EZ™ & LZ™ Serie versatil Botella Bombas y Enfriadores
EZ
™
& LZ™ Series Versatile Bottle Filling Stations & Coolers
INSTALLATION & USE MANUAL
Manual de instalación y uso
Manuel d’installation et utilisation
*Versatile Cooler Model LZSTL8WSLK
conguration as shipped
*Versatile Cooler Model LZSTL8WSLK
alternate installations
*Versatile cooler design allows units to be
installed either left-hand high and right-hand low
or left-low and right high.
Basin change may be required. See desired
rough-in to help determine if the basin change is
necessary.
Refrigerated unit must be installed on right-hand
side.

Elkay LZSTLDWS 1G Series Specifications

General

Brand	Elkay
Model	LZSTLDWS
Series	1G Series
Category	Water Dispenser
Mounting Location	Indoor
Material	Stainless Steel
Cooling Method	Compressor
Filtration	Yes
Hot Water Temperature	190°F
Cold Water Temperature	50°F
Installation	Professional installation recommended
Installation Type	Wall Mounted
Voltage	115V
Power Consumption	500 watts
Certifications	NSF 42, NSF 53
Finish	Brushed Stainless

Summary

Elkay Bottle Filling Stations & Coolers Manual Overview

Safety Precautions and Unit Identification

Highlights electrical hazards, refrigerant type, and general unit components.

Rough-In Installation: Standard Left-Hand High

Alternate Rough-In: Right-Hand High, Bottle Filler Low

Specifies alternate rough-in dimensions for right-hand high, bottle filler low models.

Alternate Rough-In: Right-Hand High, Bottle Filler High

Details alternate rough-in dimensions for right-hand high, bottle filler high models.

Alternate Rough-In: Left-Hand High, Bottle Filler High

Core Installation Procedures

Step-by-step instructions for installing cooler, starting up, and performing basic service.

Service and Maintenance Instructions

Bottle Filler Installation Steps

Step-by-step guide for installing the bottle filler unit and connecting its components.

Control Board Configuration and Settings

Alternate Mounting and Component Relocation

Instructions for moving the bottle filler and basin to alternate positions.

Wrapper, Trim Kit, and Drain Procedures

Plumbing Diagrams

Illustrates plumbing configurations for versatile bi-level units.

Wiring Diagrams and Parts Reference

Wiring Diagrams and Parts List

Electrical diagrams for units and a comprehensive parts list.

Filter Details and Outlet Location Images

Information on Watersentry filter, rough-in outlet locations, and replacement parts.