To Next PageTo Next Page
Need help?Do you have a question about the Elkron HPA700M and is the answer not in the manual?
General| Humidity | 95% non-condensing |
|---|---|
| Color | White |
| Type | Hybrid control panel |
| Power Supply | 220V AC, 50Hz |
| Material | Plastic |
| Certification | EN50131 |
Manages alarm signals via two control inputs: AL for alarm and S for system state.
Active self-diagnosis checks battery, horn, flashlight, and protection module integrity.
Covers opening enclosure, mounting, connections, and initial test procedures.
Details the siren module layout, connectors, and jumper identification.
Configures the maximum delay before the siren stops after a signal loss.
Sets the type for AL and S inputs: normally closed or double-balanced.
Defines whether AL and S inputs refer to positive or negative voltage.
Enables or disables counting alarms within a 24-hour period.
Activates flash blinking for active system state (function not EN50131 compliant).
Selects one of 8 different sound modes for the siren.
Manages tampering alarms from the optional module via siren terminals.
Disables the red system state LED (function not EN50131 compliant).
Enables the yellow LED to display faults (function not EN50131 compliant).
Details flashlight blinking, red system status LED, and yellow fault LED behavior.
Describes the optional protection module for enhanced tamper detection.
Explains how to wire the protection module to the siren and control unit.
