Owner’s Manual
To install the rear wheel follow these steps:
1. Place the bike on the kickstand.
2. Install rear wheel into the horizontal slots of
the frame wheel brackets and ensure:
a. The toothed washer engages the slot as shown.
b. The cable bracket is oriented horizontally forward as
shown.
c. The chain is around the sprocket as shown.
3. Loosely tighten the wheel nuts. The nuts should
be loose enough so that the wheel can still slide in the
wheel bracket when tensioning the chain.
4. Install the left and right chain tensioner assemblies.
Torque to 2-3 Nm.
5. Using the chain tensioners, adjust the wheel so that it is
centered in the frame and the chain is tight but not
binding. For proper chain tensioning, please
see Chain Tension Section.
Rear Wheel Installation – C-series, 8S, 11R
2a
2c 3
4
2b
5a
5b 5c
II
To Next Page
Loading...
