Owner’s Manual
The ElliptiGO Arc foot platforms and pivot axle locations are originally set at 2.5 and 2.5. Many combinations of foot
platform location and pivot axle location are not compatible. If you choose to adjust one or both of these settings,
ensure that the new settings fall in an “OK” position on the chart below. If the new combination falls in a position that
states “DO NOT RIDE”, then reset you positions so that they fall in an “OK” area of the chart. Riding in a DO NOT RIDE
position will likely result in the foot platform striking the swing arm or frame during riding, which could cause the
rider to lose control and suer a fall.
FOOT PLATFORM POSITIONING ON ARC
To Next Page
Loading...
