Why does Elma Other have no ultrasound but heating is OK?
If there's no ultrasound but the heating is working, the issue could be with the interference filter coil or the timer. In such cases, consider replacing the component or the complete interference filter.
What to do if Elma Other has no ultrasound and no heating?
If there is no ultrasound and no heating, the issue might be a faulty printed board (BZW diode; transistors; diodes mains and HF). You can try replacing the component or the complete printed board. Alternatively, disconnect the heating cable and check the unit again with new fuses. If the short circuit doesn't occur again, the heating is faulty, and you should replace it.
What to do if Elma T700 Other fuse is released, with no heating and no ultrasound?
If the fuse is released, and there's no heating or ultrasound, it indicates a short circuit in the heating system. Disconnect the heating cable and check the unit again using new fuses. If the short circuit does not occur again, it confirms that the heating is faulty. Replace the faulty heating.
Why does Elma T700 Other have no ultrasound or weak ultrasound, but heating is OK?
If there is no ultrasound or weak ultrasound, but the heating is okay, the issue could be with the output transformer, the output capacitor (6.8nF), or scorching in the transducer system. You may need to replace the component or the complete printed board, or open and check the transducer system.
What to do if Elma T700 Other has no ultrasound but heating is OK?
If there's no ultrasound but the heating is working, possible causes include a faulty printed board (BZW diode; transistors; diodes) or a short circuit in the heating. Disconnect the heating cable and check again. You might need to replace a component, the complete printed board, or the heating element.
What to do if Elma T700 has no heating but ultrasound is OK?
If there is no heating but the ultrasound is working, the issue could be a faulty heating switch. If that's the case, replace the component.
Crucial safety precautions to be observed during operation and maintenance.
Specifies the intended application and procedure to inspect the unit for damage.
Specific troubleshooting steps and possible causes for the T310(H) model.
Specific troubleshooting steps for T420(H) and LC20H models.
Specific troubleshooting for T460-T700H and LC30-LC130H models.
Specific troubleshooting steps for T780-T1060H models.
Detailed steps for replacing the timer component in the unit.
Instructions for removing and installing the heating switch.
Steps to replace the control thermostat on specific models.
Procedure to replace the overheating protection component on T310/H models.
Procedure to remove and replace overheating protection on LC models.
Detailed steps for reassembling the transducer system correctly.
General and detailed steps for repairing or replacing the ultrasonic generator.
Specific instructions for generator replacement on these models.
Specific instructions for generator replacement on these models.
Steps for replacing components on the generator print for these models.
Detailed steps for replacing transistors on the generator print for these models.
Detailed steps for replacing transistors on the generator print for these models.
Steps for replacing components on the generator print for these models.
Steps for replacing components on the generator print for these models.
Specific adjustment procedures for T310-T420H and LC20H-LC30H models.
Specific adjustment procedures for T460-T470H and LC60H models.
Specific adjustment procedures for TS540-T700H and LC130H models.
Specific adjustment procedures for T780-T1060H models.
To Next Page
General