Why does Elma Other have no ultrasound but heating is OK?
If there's no ultrasound but the heating is working, the issue could be with the interference filter coil or the timer. In such cases, consider replacing the component or the complete interference filter.
What to do if Elma T310 Other has no ultrasound and no heating?
If there is no ultrasound and no heating, the issue might be a faulty printed board (BZW diode; transistors; diodes mains and HF). You can try replacing the component or the complete printed board. Alternatively, disconnect the heating cable and check the unit again with new fuses. If the short circuit doesn't occur again, the heating is faulty, and you should replace it.
What to do if Elma T310 Other fuse is released, with no heating and no ultrasound?
If the fuse is released, and there's no heating or ultrasound, it indicates a short circuit in the heating system. Disconnect the heating cable and check the unit again using new fuses. If the short circuit does not occur again, it confirms that the heating is faulty. Replace the faulty heating.
Why does Elma Other have no ultrasound or weak ultrasound, but heating is OK?
If there is no ultrasound or weak ultrasound, but the heating is okay, the issue could be with the output transformer, the output capacitor (6.8nF), or scorching in the transducer system. You may need to replace the component or the complete printed board, or open and check the transducer system.
What to do if Elma T310 Other has no ultrasound but heating is OK?
If there's no ultrasound but the heating is working, possible causes include a faulty printed board (BZW diode; transistors; diodes) or a short circuit in the heating. Disconnect the heating cable and check again. You might need to replace a component, the complete printed board, or the heating element.
What to do if Elma T310 Other has no heating but ultrasound is OK?
If there is no heating but the ultrasound is working, the issue could be a faulty heating switch. If that's the case, replace the component.
Crucial safety guidelines for repair, maintenance, mains connection, and unit handling.
Discusses common issues like improper use, faulty units, and lack of ultrasound/heating.
Step-by-step instructions for safely removing the bottom plate of the unit.
Detailed steps for replacing the timer component, including precautions.
Step-by-step guide for replacing the heating switch, covering different models.
Instructions for replacing the control thermostat on specific unit models.
Guide to replacing the overheating protection component on specific unit models.
Lists reasons for PXE transducer disk damage, such as scorchings or tears.
Warns about the risk of electrocution from charged PXE disks.
Step-by-step instructions for replacing the ball valve, including heating Loctite.
Steps to diagnose generator issues, checking pilot lamp and other indicators.
General procedure for replacing the generator print, including transistor mounting.
Detailed steps for replacing the generator on T310-T420H, T460-T470H, TS540-T700H, T780-T1060H models.
Instructions for replacing transistors, diodes, capacitors, and resistances on the print.
Instructions for replacing transistors, varistors, diodes, and resistances on the print.
Instructions for replacing transistors, varistors, diodes, capacitors, and transformers on the print.
Detailed adjustment steps for T310-T420H, T460-T470H, TS540-T700H, T780-T1060H models.
Defines the indicators of a perfectly adjusted generator across different models.
To Next Page
General