Why does Elma T310H Other have no ultrasound but heating is OK?
If there's no ultrasound but the heating is working, the issue could be with the interference filter coil or the timer. In such cases, consider replacing the component or the complete interference filter.
What to do if Elma Other has no ultrasound and no heating?
If there is no ultrasound and no heating, the issue might be a faulty printed board (BZW diode; transistors; diodes mains and HF). You can try replacing the component or the complete printed board. Alternatively, disconnect the heating cable and check the unit again with new fuses. If the short circuit doesn't occur again, the heating is faulty, and you should replace it.
What to do if Elma T310H fuse is released, with no heating and no ultrasound?
If the fuse is released, and there's no heating or ultrasound, it indicates a short circuit in the heating system. Disconnect the heating cable and check the unit again using new fuses. If the short circuit does not occur again, it confirms that the heating is faulty. Replace the faulty heating.
Why does Elma T310H Other have no ultrasound or weak ultrasound, but heating is OK?
If there is no ultrasound or weak ultrasound, but the heating is okay, the issue could be with the output transformer, the output capacitor (6.8nF), or scorching in the transducer system. You may need to replace the component or the complete printed board, or open and check the transducer system.
What to do if Elma T310H Other has no ultrasound but heating is OK?
If there's no ultrasound but the heating is working, possible causes include a faulty printed board (BZW diode; transistors; diodes) or a short circuit in the heating. Disconnect the heating cable and check again. You might need to replace a component, the complete printed board, or the heating element.
What to do if Elma T310H has no heating but ultrasound is OK?
If there is no heating but the ultrasound is working, the issue could be a faulty heating switch. If that's the case, replace the component.
Qualifications and knowledge required for authorized service personnel.
Critical safety precautions to prevent injury and damage during operation and repair.
List of necessary tools and equipment for repair and testing procedures.
Troubleshooting guide for T310(H) model, listing malfunctions and remedies.
Troubleshooting guide for T420(H) and LC20H models, listing malfunctions and remedies.
Troubleshooting guide for T460-T700H and LC30-LC130H models.
Troubleshooting guide for T780-T1060H models, listing malfunctions and remedies.
Step-by-step instructions for removing the bottom plate of the unit.
Detailed steps for replacing the timer component in the unit.
Instructions for replacing the heating switch component.
Procedure for replacing the control thermostat on specific models.
Steps for replacing the overheating protection on T310/H models.
Procedure to remove overheating protection from LC 20H-LC 130H.
Procedure for accessing and opening the transducer system.
Steps for correctly assembling the transducer system after repair.
Detailed steps for replacing the transducer tank.
Procedure to replace ultrasonic generator on T310-T420H, LC20H-LC30H.
Procedure to replace ultrasonic generator on T460-T470H, LC60H.
Procedure to replace ultrasonic generator on TS540-T700H, LC130H.
Procedure to replace ultrasonic generator on T780-T1060H.
Replacing components on generator print for T310-T420H, LC20H-LC30H.
To Next Page
General