16
ELIMINATION PAPER BLOCKAGES
Under normal conditions and with the new roll, the green and yellow LEDS of
the printer have to be lighted on and stable. The red led, if lighted on,
indicates that it is nearing the end of paper (printing may continue unless
there is not enough paper). The blinking of yellow led indicates a malfunction
of printer and in particular:
• The print-head is lifted: lifting lever placed towards outside (Fig.6)
• Paper is jammed
To clear the jam carry out the following:
• Lift the print-head by pulling out the green lever (Fig.6)
• Remove the paper from behind, so reload it as in the previous section
• If the problem persists, check if there are pieces of paper remaining and
to do this, you need to act on the lower release lever (Fig. 6) and then
lift the front of the printer (Fig. 7).
• Remove any pieces of paper in the path
• Re-catch the front of the printer.
• Proceed to the loading of paper as in the previous section
CLEANING THE DRAGGING AND CUTTING UNIT
Depending on the quantity of tickets treated, the drag-and-cut unit cleaning
should be done at least once a week.
• Turn OFF the machine.
• Remove the sensor board, unscrewing the fixing knobs (Fig.1).
• Clean, with a soft brush (or compressed air) the inside of the passing
tickets hole on the sensor board (Fig.2).
• If necessary, remove the drag roller, lifting upwards and then outwards
the two lateral springs (Fig.3).
• Remove any pieces of ticket blocked in the ticket cutter (Fig.4)
• Replace the sensor board.
• Turn ON again the machine.
To Next Page
Loading...