55
Adjusting the shape of an eyelet
Correct the shape of the eyelet as follows:
If the eyelet gap opens, press “ ” on the stitch length
adjusting key.
If the eyelet overlaps, press “ ” on the stitch length
adjusting key.
q
Eyelet gap opens
w
Eyelet overlaps
NOTE:
The shape can be adjusted within L1 to L3 (default
setting is L2).
The eyelet is used for belt holes etc.
Sewing
Sew until the machine stops automatically.
Open the eyelet with an eyelet puncher or pointed
scissors.
q
Starting point
q
e
w
r
Eyelet
Machine settings
q Pattern: MODE 1: 33
w Thread tension: AUTO
e Presser foot: Satin stitch foot F
r Foot pressure: 5
q
w
q
L1 L3
To Next Page