Typical downloaded file installation steps (this example is for the Windows XP/Vista
driver):
• Double-click the file on the desktop
• Click Run
o For Windows Vista, if “Cannot create output file” is displayed, close the message
box, then right-click the file and select Run as Administrator
• Click OK
• Click Unzip
• Click OK
• Click Next to select English as the default language
• Click either Install USB Touchscreen Drivers or Install Serial Touchscreen Drivers
o This is determined by the choice made when the cables were connected
(see the Connections section of this document, above)
• Ignore Enable Precalibration
• Click Next
• Click Yes to indicate that you have read and accept the license agreement terms
• The files will install
• Click Finish
• If Calibration does not run automatically, see the Calibration section of this document
To Next Page
Loading...
Need help?
General
