Why does my Elsist NEMO 2.0 120 beep continuously when Mains is present?
The continuous beep from your Elsist UPS when Mains is present indicates an overload. Verify that the load connected to the UPS does not exceed its rated capacity.
What to do if the battery autonomy time in back-up mode is short in Elsist UPS?
If your Elsist UPS provides a short battery autonomy time in back-up mode, there are several potential causes: * The UPS may be overloaded. Try removing some of the load. * The battery voltage may be very low. Recharge the battery for at least 8 hours. * The battery may have failed due to high ambient temperatures or improper operation. Consider replacing the battery with the same type.
To Next Page
General
