To Next Page
M
Melissa FrenchSep 15, 2025
What does 'Auxiliary power fault' mean for Elsist POLARIS 10 UPS?
- RRhonda HatfieldSep 15, 2025
When there is an Auxiliary power fault in Elsist UPS, it will beep continuously and the Fault LED will be lit.
What does 'Auxiliary power fault' mean for Elsist POLARIS 10 UPS?
When there is an Auxiliary power fault in Elsist UPS, it will beep continuously and the Fault LED will be lit.
Why is the battery LED blinking on my Elsist POLARIS 10 when there is no battery?
If the Elsist UPS has no battery connected, the Battery LED will blink once per second.
What does it mean when the battery LED is blinking once per second on my Elsist UPS?
If the Elsist UPS detects a battery low pre-warning, the Battery LED will blink once per second.
What does 'Bypass Site Wiring Fault' mean for Elsist POLARIS 10?
If the Elsist UPS detects a bypass site wiring fault, the Fault LED will blink once per second.
What does 'Initialization fault' mean for Elsist UPS?
When there is an Initialization fault in Elsist UPS, it will beep continuously and the Fault LED will be lit.
What does 'Soft start failed' mean for Elsist UPS?
When Soft start failed in Elsist UPS, it will beep continuously and the Fault LED will be lit.
What does 'Inverter fault' mean for Elsist UPS?
When there is an Inverter fault (Including Inverter bridge is shorted) in Elsist UPS, it will beep continuously and the Fault LED will be lit.
What does 'Inverter Thyristor short' mean for Elsist POLARIS 10?
When there is an Inverter Thyristor short in Elsist UPS, it will beep continuously and the Fault LED will be lit.
What does 'Inverter Over temperature' mean for Elsist POLARIS 10?
If the Elsist UPS detects Inverter Over temperature, the Fault LED will be lit twice per second.
What does 'Mains freq. abnormal' mean for Elsist UPS?
If the Mains frequency is abnormal, the Battery LED will be lit once per 2 seconds on the Elsist UPS.
Important safety precautions regarding voltage, earthing, battery handling, and environmental conditions.
Requirements for external circuit breakers for AC supply and battery protection.
Step-by-step instructions for connecting power cables to the UPS terminal blocks.
Detailed procedure for connecting batteries, including polarity and string configurations.
Procedures and requirements for installing UPS units in parallel for increased capacity or reliability.
Procedures for starting and stopping the UPS system safely.
Procedure for completely shutting down the UPS and load, including safety precautions.
Lists operational status messages and alarm codes with corresponding LED and buzzer indicators.
General| Apparent Power | 10 kVA |
|---|---|
| Active Power | 9 kW |
| Topology | Double Conversion Online |
| Form Factor | Tower |
| Frequency | 50/60 Hz |
| Battery Type | Sealed Lead Acid (SLA) |
| Communication Interface | RS232, USB |
| Operating Temperature | 0°C to 40°C |
