Elster T-Probe User Manual

The Kent Range of Metering Products
T-Probe
For retro-fitting to V100 and V110 meters
INSTALLATION INSTRUCTIONS
The brass bodied V100 (Kent PSM) and some versions of the
thermoplastic V110, can be specified with the facility for a magnetically
operated (reed switch) pulsed output, by the retrofitting of a dedicated
probe assembly.
The probe is fitted with a 100Ω series resistor to protect the reed switch
from power surges and is usually provided with a 5 metre length of
cable, terminating in a sealed flying lead.
Most V100 and V110 meters have the probe location hole
in the body and a driving magnet fitted. V100 or V110
meters without this facility cannot be retro-fitted with
a T-probe.

Elster T-Probe Specifications

General

Brand	Elster
Model	T-Probe
Category	Measuring Instruments
Language	English

Summary

T-Probe Installation and Operation

Location and Operating Principle

Explains probe placement and how it generates pulses via magnet and reed switch.

Probe Fitting Instructions

Details the physical installation steps, including screw securing and tamperproofing.

Cable Identification and Wiring Details

Specifies cable types, core colours, and wiring variants for signal output.

Health and Safety Precautions

Health and Safety at Work Act 1974 Compliance

Information regarding product safety, installation, and handling according to regulations.