This is Flatpack Control IP address, which is set automatically and cannot be changed.
To access the Flatpack2 Control web setup page, open web browser in your device and type the
following in the address field:
http://IPaddress/dashboard
(Using the above example screenshot the address is http://192.168.4.1/dashboard)
The following page should appear, confirming you are successfully connected to setup:
2.3 Entering Flatpack2 Serial number
This is mandatory step. Flatpack2 Control will not display rectifier’s data till correct Serial No
entered and submitted.
Enter 2 digits per field, no spaces. Below is the example:
Once Serial No entered, press Submit button. Simple confirmation page will appear, informing
that Serial is entered and accepted. At this stage Flatpack2 Control should establish connectivity
with rectifier (it may take up to 5-10 seconds) and monitoring data should appear on TFT display:
To Next Page
Loading...