4. WiFi reset options
4.1 Forgotten custom SSID or Password
Make sure that custom SSID and Password is always saved somewhere. If those settings
forgotten or lost and Flatpack2 Control web setup page cannot be accessed, then the default
WiFi settings should be restored via Console. The following steps are required:
1. Download and install Arduino IDE: https://www.arduino.cc/en/software
2. Disconnect Flatpack2 Control from rectifier and AC
3. Connect ESP32 via USB to the computer with installed Arduino IDE
4. Launch Arduino IDE. Make sure that proper COM port is selected in Arduino IDE
5. Launch Serial Monitor
6. Press Reset button on ESP32 once. Some output should be visible in Serial monitor,
confirming that connection is established:
To Next Page
Loading...