Erro! Use a guia Página Inicial para aplicar Heading 1 ao texto que deverá
aparecer aqui. Erro! Use a guia Página Inicial para aplicar Heading 1 ao texto
que deverá aparecer aqui.
8 User’s Guide Flatpack2 Rectifier & Supervision Modules,
Mounting or Removing Blind Panels
Always mount blind panels in unused
Flatpack S
rectifiers’ and
Smartpack S
controllers’ locations. Do following:
To mount a blind panel
insert the panel in an unused location until the panel
engages and locks into position
To remove a blind panel
push the panel’s handle downwards and pull out to
release the panel
Removing Smartpack S Controller
To remove the
Smartpack S
controller, do following:
Unlock the controller
by
using a screwdriver to turn the locking screw ¼ of a turn
clockwise to the unlocked position (pos 2).
Notice
: in this position, the display is locked (
), see
“Accessing the Controller’s Ethernet Port” on page
<ET>
Remove the controller
by
using the controller’s handle to pull the module loose.
Support from underneath before the unit is completely free
Mount blind panels
in
unused module locations
Mounting Smartpack S Controller
To mount the
Smartpack S
controller, do following:
Unlock the controller
by
using a screwdriver to turn the locking screw ¼ of a turn
clockwise to the unlocked position (pos 2)
Notice
: the controllers may be mounted in the power
shelf with the locking screw in both locked and unlocked
positions
Insert the controller
by
sliding it fully into the power shelf, so that it makes proper
contact. Support from underneath
To Next Page
Loading...
