Need help?Do you have a question about the Eltek Smartpack and is the answer not in the manual?
General| Output Voltage | 48 VDC |
|---|---|
| Power Output | 2000 W |
| Communication Interface | RS-232/RS-485 |
| Output Current | Up to 40 A |
| Cooling | Fan-cooled |
| Protection | Overvoltage, overcurrent, overtemperature, short circuit protection |
Provides information on using the Smartpack controller and its front panel.
Illustrates the overall system architecture of the Flatpack2 power supply.
Lists main capabilities and shows the controller's internal structure.
Describes typical uses and identifies physical ports on the controller.
Details internal wiring and signals for system and battery monitoring.
Explains how to connect external alarms and digital inputs.
Covers CAN bus signals, addressing, hardware assignment, and termination.
Details standard features and the Ethernet option for remote control.
Explains RS232 options (front/rear access) and port signals.
Describes the Smartnode module for protocol translation.
Covers safety, mounting, removing, and blind panel removal.
Details keys, display, and LED indicators on the front panel.
Explains operating modes (Status/Menu) and menu navigation.
Details user and password-protected service configuration options.
Covers remote/local monitoring and control methods.
Summarizes key system features and available alarms.
Details system input voltage, dimensions, and rectifier information.
Explains how to reset alarms and view alarm messages.
Describes how to view various system voltage parameters.
Shows how to check controller firmware version and retrieve serial numbers.
Details viewing rectifier status, serial numbers, and plug-and-play behavior.
Covers mains phase assignment, rectifier ID handling, and reset procedures.
Describes viewing battery temperature levels and system mains data.
Details methods for measuring battery symmetry in 48V systems.
To Next Page
