Eltek Minipack - User Manual

Quick Start Guide
Installation, Operation, Commissioning and Maintenance
DC Power Supply System
Integrated Applications
Mini
p
ack, PS S
y
stem
356808.103
Miscellaneous
Communication
o CAN Bus Termination (13)
o Installing PowerSuite – PC software (13)
AC Mains
o Mains Feeds versus Rectifier ID (14)
o Plug-and-Play Rectifiers versus Mains Monitoring (14)
Battery Monitoring
o Battery Symmetry – Connections (15)
o Battery Interface Card ~ Terminals & Pin-out, ( 16)
Alarms & Monitoring
o Standard Alarm Relays & Digital Inputs (17)
o Alarm Interface Card ~ Terminals & Pin-out (17)
o Alarm Interface Card, Extd. ~ Terminals & Pin-out (18)
Internal Connections
o System Interface Card ~ Terminals & Pin-out (19)
o LVD Latching Contactors (19)
Drawings
o Block Diagram Minipack 48VDC, 3.2kW (21)
o Block Diagram Minipack 48VDC, 4.8kW (22)
Introduction
o The Smartpack based Product Range (2 )
o Brief System Description ⎯ Minipack (2 )
Installation
o Installing Smartpack and Rectifier Modules ( 3)
o Installation and Maintenance Details
⎯ Opening or Closing the Minipack Drawer Shelf (4)
⎯ Mounting or Removing Minipack Blind Covers (4)
⎯ Removing or Mounting Load MCBs (5)
⎯ Configuring Priority and Non-Priority Load Circuits (5)
o Installation steps; mechanical, electrical (6-7)
o Location of Components, GA drawing; 6 and 4 rectifiers systems (8)
o Connections, Factory Settings, etc. (9)
Commissioning
o Pre-start check (10 )
o Commissioning steps, Startup (10-11)
Operation
o Front keys and display (12)
o Software Menus (12)
Check Lists pullout forms
o Installation Check List
o Circuit Distribution List
o Commissioning Procedure
o Maintenance Procedure

Summary

Introduction to Minipack PS System

Minipack PS System Description

Description of the Minipack PS system as a compact DC power supply for the telecom industry.

Minipack PS System Installation Guide

Installing Smartpack and Rectifier Modules

Instructions for installing and removing Smartpack controller and Minipack rectifier modules.

Load MCB Installation and Configuration

Site Preparation and Mechanical Installation

Guide to preparing the installation site and performing mechanical installation steps.

Electrical Installation Procedures

Connecting AC power, DC earth, load circuits, and alarm/signal circuits.

Connections and Factory Settings

Minipack PS System Commissioning Process

Pre-Start Check Procedure

Ensures system installation is complete and all pre-conditions are met before powering on.

Startup and No-Load Adjustments

Steps to switch on the system, disconnect load, and adjust output voltage.

Load Adjustments and Final Checks

Adjusting DC output to battery voltage and connecting loads after initial startup.

Miscellaneous System Information

Installing PowerSuite PC Application

Battery Monitoring and Symmetry

Battery Interface Card Connections

Alarm Relays and Digital Inputs

Extended Alarm Interface Card

System Interface Card and LVD Contactors

Installation Check List

Commissioning Procedure Checklist

Maintenance Procedure Checklist

Eltek Minipack Specifications

General

Brand	Eltek
Model	Minipack
Category	Power Supply
Language	English