Eltek Squirrel 1000 Series - The MODE Function

21
Baud rate Minimum logging interval
300 10 seconds
1200 3 seconds
2400 2 seconds
4800 - 38400 1 second
4.8 The MODE function
Once you have entered this function using the function button, press
select to select from the following sub-functions. (Please note that you
cannot change any entries in the MODE function while logging is in
progress or while readings are still stored in the memory).
4.8.1 Mode log
Press set to change the type of logging required from the following
options.
4.8.2 Interval logging
M
O
D
E
l
o
g
i
n
t
e
r
v
a
l
The inputs from each channel selected are measured at each logging
interval and stored in memory. Pulse inputs record the total number of
pulses received during this interval. The logger records the first readings
as soon as logging is started, although pulse inputs record a dummy value
at this point. Please see section 3.2 for instructions on how to change
logging intervals.
4.8.3 Logging averages
M
O
D
E
l
o
g
a
v
e
r
a
g
e
In this option, the inputs from each channel selected are measured at
each sample interval, which is set at a shorter interval than the logging
interval. All the sample interval readings taken within the logging interval
period are averaged. This average is then recorded at each logging
interval. Readings from pulse count channels and event/digital channels
cannot be averaged and the actual values at the end of the logging
interval are stored. Please see section 3.2 for instructions on how to
change sample intervals. After any change between interval and average
modes, the following will be displayed as a reminder: -