4
1. Introduction
This user manual covers the operation and configuration of the Squirrel
datalogger via the three operating buttons on its front panel. The Squirrel
can also be configured and operated from a connected PC running Eltek’s
Darca software. The operating buttons on the front of the logger allow the
setup of nearly all of the major functions of the logger, but some functions
can only be accessed through Darca. These include:
· Scaling EU units in a channel
· SMS Alarm operation
For more information on using Darca, consult the document TM1020.
Overview of the operating buttons
function selects the function.
select selects the channel or
sub function.
set is used to change any of
the settings.
To switch the datalogger on, press and hold function. To switch it off,
leave in LOG or OUTPUT function for a few seconds. If the datalogger is
left on in any other function, it will automatically switch off after 4 minutes.
To Next Page
Loading...