ELTEX ESR-10 - Page 157

ESR series service routers.ESR-Series. User manual
157
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Step Description Command Keys
2 Set the necessary serial interface
parameters to communicate with the
connected device (optional).
These parameters are usually specified
in the operation manual of the device to
be connected.
By default, the standard values will be
used.
esr(config-line-aux) databits
<BITS>
esr(config-line-aux)
flowcontrol <FMODE>
esr(config-line-aux) parity
<PMODE>
esr(config-line-aux) speed
<SPEED>
esr(config-line-aux) stopbits
<STOP-BITS>
<BITS> – a number of data bits sent
[7..8].
Default is '8'.
<FMODE> – data flow control
mode. Takes the following values:
software – software flow
control;
hardware – hardware flow
control;
disabled – flow control
disabled;
Default is 'disabled'.
<PMODE> – parity bit setting mode.
Takes the following values:
odd – a check for oddness;
even – a check for evenness;
none – parity bit is not set;
Default is 'none'.
<SPEED> – a speed of a serial
interface in bps.
Takes the following values:
300;
1200;
2400;
4800;
9600;
19200;
38400;
57600;
115200;
Default is '115200'.
<STOP-BITS> – the number of stop
bits transmitted[ 1..2];
Default is '1'.
3 Specify serial interface description
(optional).
esr(config-line-aux)#
description <DESCRIPTION>
<DESCRIPTION> – interface
description, set by the string of up
to 255 characters.