ELTEX ESR-10 - Configuration Process; Configuration Example

ESR series service routers.ESR-Series. User manual
614
•
•
•
17.7.1 Configuration process
Step Description Command Keys
1 Switch to the configuration file
backup mode.
esr(config)# archive
2 Set router configuration backup
type (optional).
esr(config-ahchive)# type
<TYPE>
<TYPE> – type of the router
configuration backup. Takes the
following values:
local;
remote;
both.
Default value: remote.
3 Enable timer configuration
backup mode (optional).
esr(config-ahchive)# auto
4 Enable configuration backup after
each successful configuration
application mode (optional).
esr(config-ahchive)# by-
commit
5 Specify a path for remote copying
of the router configuration
(required for remote and both
types).
esr(config-ahchive)# path
<PATH>
<PATH> – defines the protocol, server
address, location and prefix of the file
name on the server
6 Set a period of time for automatic
configuration backup (optional,
relevant only for auto mode).
esr(config-ahchive)# time-
period <TIME>
<TIME> – periodicity of automatic
redundancy of the configuration, takes
the value in minutes [1..35791394].
Default value: 720 minutes.
7 Set the maximum number of
locally saved configuration
backups (optional, relevant for
local and both types).
esr(config-ahchive)# count-
backup <NUM>
<NUM> – set the maximum number of
locally saved configuration backups.
Takes values in the range of [1..100].
Default value: 1.
17.7.2 Configuration example
Objective:
Configure local and remote backup of the router configuration once a day and upon successful configuration
change. Remote copies should be sent to the TFTP server 172.16.252.77 in the esr-example subfolder. The
maximum number of local copies is 30.