ELTEX ESR-10 - Page 506

ESR series service routers.ESR-Series. User manual
506
•
•
•
•
•
•
Step Description Command Keys
20 Define a description of a set of
user rules (optional).
esr(config-ips-category)#
description <DESCRIPTION>
<DESCRIPTION> – description, set by
the string of up to 255 characters.
21 Create a rule and switch to its
configuration mode.
esr(config-ips-category)# rule
<ORDER>
<ORDER> – rule number, takes values
of [1..512].
22 Specify rule description
(optional).
esr(config-ips-category-rule)#
description <DESCRIPTION>
<DESCRIPTION> – description, set by
the string of up to 255 characters.
23 Specify the given rule force. esr(config-ips-category-rule)#
action { alert | reject | pass |
drop }
alert – traffic is allowed and the
IPS/IDS service generates a
message;
reject – traffic is prohibited. If it
is TCP traffic, a TCP-RESET
packet is sent to the sender
and recipient, for the rest of the
traffic type, an ICMP-ERROR
packet is sent. IPS/IDS service
generates a message;
pass – traffic transfer is
permitted;
drop – traffic is prohibited and
the IPS/IDS service generates a
message.
24 Set the IP protocol to HTTP. esr(config-ips-category-rule)#
protocol http
25 Set sender IP addresses for
which the rule should work.
esr(config-ips-category-rule)#
source-address
{ip <ADDR> | ip-prefix <ADDR/
LEN> | object-group
<OBJ_GR_NAME> | policy-
object-group { protect |
external } | any }
<ADDR> – sender IP address, defined
as AAA.BBB.CCC.DDD where each
part takes values of [0..255];
<ADDR/LEN> – sender IP subnet,
defined as AAA.BBB.CCC.DDD/EE
where each part AAA-DDD takes
values of [0..255] and LEN takes
values of [1..32].
<OBJ_GR_NAME> – name of IP
addresses profile that contains sender
IP address, set by the string of up to
31 characters.
protect – sets sender
addresses, protect addresses
defined in IPS/IDS policy;
external – sets external
addresses defined in IPS/IDS
policy as sender addresses.
When specifying the 'any' value, the
rule will be triggered for any source IP
address.