ELTEX ESR-10 - Page 519

ESR series service routers.ESR-Series. User manual
519
•
•
Step Description Command Keys
17 Specify authentication algorithm
(optional).
esr(config-if-gi)# vrrp
authentication algorithm
<ALGORITHM>
<ALGORITHM> – authentication
algorithm:
cleartext – password,
transmitted in clear text;
md5 – password is hashed
by md5 algorithm.
18 Specify VRRP version (optional). esr(config-if-gi)# vrrp version
<VERSION>
<VERSION> – VRRP version: 2, 3.
19 Set the mode when vrrp IP address
remains in the UP status regardless
of the status of the interface itself
(optional).
esr(config-if-gi)# vrrp force-up
20 Specify the delay between the
assignment of MASTER status to
ipv6 vrrp and the start of ND
messages distribution (optional).
esr(config-if-gi)# ipv6 vrrp timers
nd delay <TIME>
<TIME> – time in seconds, takes
values of [1..60].
Default value: 5.
21 Specify the period of ND protocol
information update for ipv6 vrrp in
MASTER status (optional).
esr(config-if-gi)# ipv6 vrrp timers
nd refresh <TIME>
<TIME> – time in seconds, takes
values of [1..65535].
Default value: 5.
22 Specify the amount of ND
messages sent in the update period
for ipv6 vrrp in MASTER status
(optional).
esr(config-if-gi)# ipv6 vrrp timers
nd refresh-repeat <NUM>
<NUM> – amount, takes values of
[1..60].
Default value: 0.
23 Specify the amount of ND packets
sendings after setting ipv6 vrrp to
the MASTER status (optional).
esr(config-if-gi)# ipv6 vrrp timers
nd repeat <NUM>
<NUM> – amount, takes values of
[1..60].
Default value: 1.