What does error text: 11 calibration mean for my ELTEX KNH65?
The error text '11 calibration' indicates defective or missing calibration data in the EEPROM. This signifies a memory problem, and the unit should be sent for repairs.
What to do if my ELTEX KNH65 Portable Generator displays error text: 04 short-circuit?
If your ELTEX Portable Generator displays the error text '04 short-circuit', it indicates a short-circuit has been detected. To resolve this, disconnect the connected consumers one after the other to identify and isolate the short-circuit.
What does error text 30 temperature rise mean for my ELTEX KNH65 and how to fix it?
Error text 30 'temperature rise' indicates that the internal temperature of your ELTEX Portable Generator is too high. Here's what you can do: * Check the maximum permissible temperature and reduce the generator load if necessary. * Verify the installation position, as heat loss is best when the generator is mounted in a hanging position. * Ensure adequate air circulation if the generator is inside a cabinet.
What to do if my ELTEX KNH65 Portable Generator displays error text: 02 spark counter 1?
If your ELTEX Portable Generator displays the error text '02 spark counter 1', it means there were 5 high-power discharges within a short period. To fix this, reduce the output voltage and clean the bars as described in the Maintenance section.
What does error text: 16 mains voltage mean on my ELTEX Portable Generator?
The error text '16 mains voltage' on your ELTEX Portable Generator indicates that the generator, operating with 115 V mains voltage, has detected a non-permissible mains voltage. Acknowledge the error by switching the generator off and then back on. If the error reappears, inspect the supply network for voltage peaks and contact Eltex if needed.
What does error text: 03 spark counter 2 mean on my ELTEX KNH65 Portable Generator?
The error text '03 spark counter 2' indicates that the processor measuring range was exceeded. To resolve this, reduce the output voltage, clean the bars (see Maintenance), and check the high voltage cables.
What does error text: 105 release analog mean for my ELTEX KNH65?
The error text '105 release analog' means that before activating the release source analog setpoint, the parameter ext. setpoint must be set to .
What does error text: 106 release setpoint mean for my ELTEX Portable Generator?
The error text '106 release setpoint' means that before deactivating the ext. setpoint, the release source ext. setpoint must be deactivated.
What does error text: 33 service data mean for my ELTEX KNH65?
The error text '33 service data' indicates an error in the service data. Acknowledge the error. If it recurs, it indicates a memory problem, and the unit should be sent for repairs.
What does error text: 31 watchdog mean on ELTEX KNH65 Portable Generator?
The error text '31 watchdog' indicates an error in the electronics of your ELTEX Portable Generator. Switch the appliance off and back on. If the error persists, contact Eltex Service.
Symbols identifying potential risks and hazards during operation.
Essential safety rules and precautions for safe operation and maintenance.
Requirements for establishing a permanent and safe ground connection.
Procedure for powering on the generator and initial operation.
Details on specific setting options and default factory configurations for the generator.
Accessing and modifying operating parameters requires password entry.
List of common defects, their causes, and recommended remedies.
General| Brand | ELTEX |
|---|---|
| Model | KNH65 |
| Category | Portable Generator |
| Language | English |
To Next Page
