EasyManua.ls Logo

ELTEX NTU-RG-1402G-W - Reboot and Factory Reset

Default Icon
55 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
____________________________________________________________________________________
____________________________________________________________________________________
22 NTU-2V, NTU-RG Optical Network Terminals
4.1.5 The Route Submenu. The Routing Table
The menu shows the routing table.
Destination destination IP address;
Gateway gateway IP address;
Subnet mask subnet mask (Genmask);
Flag routing flag:
U active routing;
I inactive routing, packets will be rejected;
G the routing uses gateway;
H destination is a separate host;
R restored routing;
D the routing was created after receiving a redirected ICMP message;
M the routing was changed by a redirected ICMP message;
Metric routing priority;
Service a service the routing is associated with;
Interface an interface the routing is associated with.
4.1.6 The ARP Submenu. Display of the ARP Protocol Cache
The ARP efficiency depends a lot on ARP cache presented in every host. The cache contains Internet
addresses and corresponding MAC addresses. Every record is stored in cache for 5 minutes since its creation.
IP-address client IP address;
Flags status flags:
Complete active client;
Incomplete client does not respond to ARP queries;
HW-Address client MAC address;
Device client interface.

Table of Contents

Other manuals for ELTEX NTU-RG-1402G-W

Related product manuals