ELTEX NTU-RG-1402G-W - Filtration Settings for Incoming Traffic

____________________________________________________________________________________
____________________________________________________________________________________
30 NTU-2V, NTU-RG Optical Network Terminals
Click the Add button to add a new filtration rule.
– Filter Name – filter text description;
– IP Version – IP protocol version;
– Protocol – selected protocol (TCP/UDP, TCP, UDP, ICMP);
– MAC address – source MAC address;
– Source IP address[/prefix length] – source IP address (prefix length can be specified after slash);
– Source Port (port or port:port) – source port or a range of ports separated by a colon;
– Destination IP address[/prefix length] – destination IP address (prefix length can be specified after
slash);
– Destination Port (port or port:port) – destination port or a range of ports separated by a colon.
Click the Apply/Save button to accept and save the settings.
Filtration Settings for Incoming Traffic
When a firewall is turned on in a WAN or LAN interface, all incoming traffic which does not satisfy the
set rules will be blocked.