____________________________________________________________________________________
____________________________________________________________________________________
NTU Optical Network Terminals 39
– Enable Wireless — enables Wi-Fi on the device
Wireless —Access Point—wireless network configuration:
– Enable Access Point—enable Hotspot2.0 support on the device
– Hide Access Point—access point hidden operation mode (in this mode, wireless network SSID won't be
broadcast by the router)
– Clients Isolation—when checked, wireless clients will not be able to interact with each other
– Disable WMM Advertise—disable WMM (Wi-Fi Multimedia—a QoS for wireless networks)
– Enable Wireless Multicast Forwarding (WMF)—enable WMF
– SSID (Service Set Identifier)—assign a wireless network name (case sensitive)
Default device SSID is ELTX-2.4GHz_WiFi__aaaa/ELTX-5GHz_WiFi_aaaa, where аааа—the last 4 digits
of WAN MAC. WAN MAC is labelled on the device housing. The network name contains a frequency
band (2.4/5GHz).
– BSSID—МАС address of the access point
– Country—specifies location (country)
– Country RegRev—specifies region ID (0-34 for Russia);
– Max Clients—the maximum possible number of simultaneously supported wireless connections.
Click the Apply/Save to accept the changes.
To Next Page
Loading...
