traceroute [df-bit][repeat <value>][timeout <value>][ttl <value>][tos <value>][icmp] [port <value>][size
<value>] destination
Parameters
df-bit-set ‘don't fragment bit’;
repeat-retries amount within one 'ttl';
timeout-reply witing time, s;
ttl-max time-to-live amount;
tos-type of service;
icmp-use ICMP ECHO instead of UDP datagrams;
port-number of used UDP-port;
size-packet size in bytes;
destination-destination host address.
< value > parameter value:
for repeat: 1-8 (default is 2);
for timeout: 0-10 (default is 2);
for ttl: 1-255 (default is 255);
for tos: 0-255 (default is 0);
for port: 1-65535 (default is 33434);
for size: 40-32768 (default is 100);
Privilegy
none
Command mode
EXEC
Example
tau-72> traceroute 192.168.118.46
traceroute to 192.168.118.46 (192.168.118.46), 255 hops max, 100 byte
packets
1 192.168.118.46 (192.168.118.46) 1.510 ms 1.053 ms
show system
The command is intended for viewing firmware version.
Syntax.
show system
Parameters
Command contains no arguments.
Privilegy
none
Command mode
EXEC
Example
To Next Page
Loading...
