ELTEX TAU-36.IP - Настройки Портов Коммутатора

________________________________________________________________________________
_________________________________________________________________________________
Universal Network Terminal TAU-72.IP/TAU-36.IP 261
presence of NAT
NATAddress
IP address of a public NAT
String, 40 characters max.
STUNEnable
Use STUN protocol for public address
identification
0-disable
1-enable
STUNServerAddress
STUN server IP address or domain name
String, 40 characters max.
STUNServerPort
STUN server UDP port
1-65535; default is 3478
STUNMinimumKeepAlivePeriod
The time interval in seconds for periodic
transmission of messages to STUN
server for public address discovery and
modification, in seconds
0-100000
STUNMaximumKeepAlivePeriod
The time interval in seconds for periodic
transmission of messages to STUN
server for public address discovery and
modification, in seconds
0-100000
9.1.3 Настройки портов коммутатора
Table 15–Switch port settings (Switch)
Field name
Description
Values
vlan
example of switch configuration using VLAN
hubmode
Ethernet switch operation in hub
mode
0-disable
1-enable
Port mapping:
0—GE0 (GE2)
1—GE1 (GE1)
2—GE2 (GE0)
3—CPU port (CPU)
4—SFP0 port (SFP0)
5—SFP1 port (SFP1)
In models of with one SFP port is used only SFP0
portmask0..5
Mutual availability of data ports.
Defines the port that will receive
the data from this port.
A B C D E F,
where
A – port 0
B – port 1
C – port 2
D – port 3
E – port 4
F – port 5
A, B, C, D, E, and F may take the following values:
0—data transmission to port is disabled
1—data transmission to port is enabled
enable0..5
Use 'Default VLAN ID', 'Override'
and 'Egress' settings on ports 0..5
0-disable
1-enable
vid0..5
Default VLAN ID
1-4095
im0..5
IEEE mode for ports 0-5
0 – fallback
1 – check
2 – secure
eg0..5
Packet transfer rules for ports 0..5
0—unmodified—packets will be sent by the port
without any changes