ELTEX TAU-36.IP - Call Statistic; Command Line Mode

________________________________________________________________________________
_________________________________________________________________________________
Universal Network Terminal TAU-72.IP/TAU-36.IP 221
tau-72(config-voice-profile)#
6.2 Call statistic
6.2.1 Command line mode
CLI is available when the connection to the device is established via RS-232 (connection parameters: 115200,
8, n, 1, n; username: admin, w/o password), or Telnet/SSH.
To view the current call statistics, use show call history command.
Device RAM may store up to 2000 performed calls records. When the number of records exceeds 2000, the
oldest records will be deleted, and the new ones will be added at the end of the file.
Table 10—Call statistics record format.
Record
Description
No
Sequence number of the record
Local
TAU-72.IP/TAU-36.IP subscriber number
Remote
Remote subscriber number
Remote host
Remote host IP address
Start call time
Call received/performed time
Start talk time
call start time
Duration
Duration of call (seconds)
State
Transient state, or reason for call clearing
Type
Call type (outgoing, incoming)
Table 11 - Transient states and reasons for call clearing output into statistics
Transient states
Description
seize
Incoming or outgoing occupation
talking
Subscriber in the call state
holding
TAU-72.IP/TAU-36.IP subscriber put a remote subscriber on hold
holded
TAU-72.IP/TAU-36.IP subscriber was put on hold by a remote subscriber
conference
Conference state, the subscriber is a 3-way conference initiator
Reasons for call clearing
Description
local
TAU-72.IP/TAU-36.IP subscriber put the phone offhook, didn't perform a call and
put the phone back onhook
local busy
TAU-72.IP/TAU-36.IP subscriber is busy
remote busy
Remote subscriber is busy
invalid number
Invalid number is dialled
no answer
No response from subscriber
no local user
Incoming call to non-existent number
no remote user
Outgoing call to non-existent number
no route
Call to unavailable direction
local clear
TAU-72.IP/TAU-36.IP subscriber clearback
remote clear
Remote subscriber clearback
local fail
Local or remote failure that has occurred during the connection establishment.
Possible error reasons: codec mismatch, problems during ТСР connection
establishment (when Н.323 is used), overload, resource bottlenecks
(bandwidth), etc.
remote fail
remote redirection
Redirection (before—CFB, CFNR, or after the call—CT) performed by the remote
subscriber
local redirection
Redirection (before—CFB, CFNR, or after the call—CT) performed by TAU-
72.IP/TAU-36.IP subscriber
replaced
This call is replaced by another one while performing 'Call Transfer' service
pickuped
Call is picked up