Erasing 13 sectors... ......ok
Copy to Flash... ................ok
done
FXS-72>>
12 To update the media processor firmware, use run updatemsp command:
FXS-72>> run updatemsp
Using comcerto_gemac0 device
TFTP from server 192.168.16.44; our IP address is 192.168.16.112
Filename 'chagall/300/firmware.elf'.
Load address: 0x1000000
Loading: #################################################################
#################################################################
#################################################################
#################################################################
#################################################################
#############################
done
Bytes transferred = 1809497 (1b9c59 hex)
Erase Flash Sectors 24-55 in Bank # 2
Erasing 32 sectors... ................ok
Copy to Flash... ..........................ok
done
FXS-72>>
13 To update the file system, use run updatefs command:
FXS-72>> run updatefs
Using comcerto_gemac0 device
TFTP from server 192.168.16.44; our IP address is 192.168.16.112
Filename 'chagall/300/initrd.300'.
Load address: 0x1000000
Loading: #################################################################
#################################################################
#################################################################
#################################################################
#################################################################
#################################################################
#################################################################
#################################################################
#################################################################
#################################################################
#################################################################
####################
done
Bytes transferred = 3759224 (395c78 hex)
Erase Flash Sectors 56-183 in Bank # 2
Erasing 128 sectors... ...................................................ok
Copy to Flash... .....................................................ok
done
FXS-72>>
14 Start up the device using 'run bootcmd' command.