05:11:68:74:74:70:3A:2F:2F:61:75:74:6F:2E:72:75:3A:38:30:06:09:61:75:74:6F:2E:63:6F:6E:66:07:08
:61:75:74:6F:2E:76:65:72
where:
05—autoupdate server address suboption number;
11—length, 17bytes (0х11 = 17 dec);
68:74:74:70:3A:2F:2F:61:75:74:6F:2E:72:75:3A:38:30—suboption value (http://auto.ru:80);
06—configuration file name suboption number;
09—length, 9bytes;
61:75:74:6F:2E:63:6F:6E:66—suboption value (auto.conf);
07—software file name suboption number;
08—length, 8bytes;
61:75:74:6F:2E:6B:6D:67—suboption value (auto.ver).
Option 66 syntax: TFTP server FQDN or IP address
DHCP server configuration examples:
Option tftp-server-name 'update.local'
Option tftp-server-name '192.168.1.3'
Option 67 syntax: 'tau.versions file name and path; Configuration file name and path'
Syntax tau.versions file path: conf-path/tau.versions
Syntax Configuration file path and name: conf-path/tau72_<MAC>.dat
Where сonf-path—configuration file path;
Example of Option 66 and 67 syntax, software file path and name, and gateway configuration for MAC address
A8F94B887D27
Transferred parameters:
Option tftp-server-name 'update.local';
Option bootfile-name ‘/tau72ip/firmware/tau.versions;/tau72ip/conf/tau72_<MAC>.dat’
Method 2: Using autoupdate parameter configuration, specified in 'Autoupdate Settings' section, when the
static address is assigned in network settings, or when PPPoE is selected.
In this case, 'Autoupdate protocol', 'Autoupdate server', 'Configuration file' and 'Firmware versions file'
parameters are used, defined in 'Autoupdate Settings' section. If autoupdate server requires authorization,
configure the following parameters: Autoupdate auth, Username, Password.
3.1. tau.versions file format and syntax
Format and syntax
FS={FSversion} firmware-pathFS/filenameFS
CSP={CSPversion} firmware-pathCSP/filenameCSP
MSP={MSPversion} firmware-pathMSP/filenameMSP
IMG={IMGversion} firmware-pathIMG/filenameIMG
ARM={ARMversion} firmware-pathARM/filenameARM
Where FSversion/CSPversion/MSPversion/ARMversion—respective software version number;
firmware-pathFS,CSP,MSP,ARM—path to the respective software file;
filenameFS,CSP,MSP,ARM—name of the respective software file.
To Next Page
Loading...
