EasyManua.ls Logo

eluminocity GridCharge - Before Installation; Electric Shock Risk Instructions

eluminocity GridCharge
10 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Before Installation
INSTRUCTIONS PERTAINING TO THE RISK OF ELECTRIC SHOCK
Read all the instructions before using this product.
This device should be supervised when used around children.
Do not put fingers into the electric vehicle connector.
Do not use this product if the flexible power cord or EV cable are frayed, have broken
insulation, or any other signs of damage.
Do not use this product if the enclosure or the EV connector is broken, cracked, open, or
shows any other indication of damage.
A device employing pressure terminal connectors for field wiring connections shall be
provided with instructions specifying a range of values or a nominal value of tightening
torque to be applied to the clamping screws of the terminal connectors.
Only for hardwired unit:
CAUTION – To reduce the risk of fire, connect only to a circuit provided with below amperes
maximum branch circuit overcurrent protection in accordance with the National Electrical
Code, ANSI/NFPA 70.
Model Current rating
CH-21140 50 A
CH-21130 40 A
Only for cord connected unit:
CAUTION – To reduce the risk of fire, connect only to a circuit provided with below amperes
maximum branch circuit overcurrent protection in accordance with the National Electrical
Code, ANSI/NFPA 70.
Model Current rating
CH-21140 50 A
CH-21130 40 A
*NEMA 6-50P wall plug required for cord connected models. Receptacle installed with the
ground facing down.
Installation-manual_CH-211
v1.0.4