Elvaco CMe3100 DLMS Plugin - Dlms Push Report Settings; Push Notifications; Default Dlms Server Settings

CMe3100 DLMS Plugin User's Manual
CMe3100 DLMS Plugin User's Manual
page | 22 (48)
2022-02-23
Version 1.8
6.1 DLMS Push Report settings
Navigate to Configuration > Push Reports and click the menu tab DLMS Settings to access the
configuration page, see Figure 10.
Figure 10 Push Reports - DLMS settings
6.2 Push notifications
Enable or disable the Push notification when meter list changed by check/uncheck the checkbox.
When enabled, the product will send an event to the default DLMS server when a meter is
added, updated or removed.
See 7.6.2.1 for more information about the Push notifications.
6.3 Default DLMS server settings
Enter the default server address (IP or hostname) and TCP port to be used when sending push
reports. The backup server address and TCP port is used as a fallback if a push report fails when
trying to connect to the default server.
Enable or disable encrypted communication by check/uncheck the Encrypt communication
checkbox.