CMe3100 DLMS Plugin User's Manual
CMe3100 DLMS Plugin User's Manual
6.4 Enable Push Report of Load Profile/Billing Profile
Click on the report (Report 1 to Report 5) in the Push Reports page to access the individual push
report configuration page. Select DLMS in the drop-down field Report type, see Figure 11.
Figure 11 Report type DLMS
6.4.1 Select report type and schedule
Select report type 9010 (Load profile 1), 9011 (Load profile 2) or 9012 (Billing profile) in the drop-
down field Report template.
Configure desired report schedule by selecting one of the items in the drop-down field Report
schedule. The Meter readout schedule is read-only, and shows the current read out schedule for
meters connected to the Product.
Please note that the report schedule should be a multiple of the meter readout schedule.
The report is sent as soon as the last meter readout cycle has completed. For example, setting
the meter readout schedule to 15 minutes and selecting 1 hour for load profile 1, a report will be
sent as soon as every 4
th
readout cycle completes.
In the Report content section (Figure 12), select the values to include in the report based on how
long ago they were stored compared to when the report is sent. Use setting “Auto” to include all
values not sent since last report was sent.
The Value interval is defined by the load profile/billing profile setting. See section 5.2.5 how to
configure the individual load profile/billing profile value interval.
Figure 12 Report content
To Next Page
Loading...