What to do if my EMAK Tiller engine doesn't start?
If your EMAK Tiller engine doesn't start or shuts off shortly after starting, there could be a couple of reasons. First, check the spark plug for a spark. If there's no spark, try again with a new spark plug. Second, the engine might be flooded.
Why EMAK Bertolini 202 Tiller engine doesn't reach full speed?
If your EMAK Tiller engine is not reaching full speed and/or emitting excessive smoke: * The air filter may be dirty. In this case you should clean it following the instructions in the air filter maintenance chapter. * The carburetor may need adjustment. In this case you should contact an Authorized Service Center to adjust the carburetor.
Why is my EMAK Bertolini 202 vibrating so much?
If you are experiencing abnormal vibrations with your EMAK Tiller, it could be due to a couple of issues: * Damaged tools: Replace them. * Loose elements: Tighten them.
Why is my EMAK Tiller so noisy?
If the EMAK Tiller machine or gearbox is noisy, consider the following: 1. Damaged or loose tools: Secure the tools. 2. Loose protective housings: Tighten the bolts. 3. Poor lubrication: Top up the oil to the correct level.
What to do if EMAK Bertolini 202 won't idle?
If the EMAK Tiller engine starts, runs, and accelerates but won't idle, the carburetor likely needs adjustment. Contact an Authorized Service Center to adjust the carburetor.
Why EMAK Tiller not accelerating correctly?
If the EMAK Tiller engine starts but doesn't accelerate correctly or doesn't function properly at high speed, the carburetor likely needs adjustment. Contact an Authorized Service Center to adjust the carburetor.
How to prevent EMAK Bertolini 202 Tiller tools from breaking?
If the tools of EMAK Tiller are prematurely breaking, it may be due to stony ground. You should do a preventive exploration of the ground.
Warns about hearing damage from noise exposure above 85 dB(A).
Warns about vibration effects on circulation and nerves, recommending medical advice if symptoms occur.
Details required safety gear like gloves, boots, goggles, and hearing protection for user safety.
Instructions for fitting the safety guard, mandatory for certain cutting widths.
Safety guidelines for handling flammable gasoline and fuel fumes.
Procedure for safely refuelling the machine, including safety warnings.
To Next Page
General